Doepfer MTC64 Midi to Gate Interface (main board) Manuel d'utilisateur télécharger pdf (Page 15)

MTC64 V2 User’s Guide Page 15

CTM64

The counterpart to MTC64 is the

ontact

IDI interface CTM64 that converts up to 64

free contacts into 64 succeeding note or program change messages. Closing a contact

connected to the CTM64 causes the transmission of the corresponding MIDI note or program

change message. CTM64 can be used to retrofit keyboards, switches, button arrangements

or any other types of contactes with MIDI out.

A typical application of CTM64 and MTC64 is the following:

Contacts → CTM64 → (Computer-Sequencer) → MTC64 → lamps/relays/electromagnets

This arrangement can be used to record any contact operations with a computer sequencer

and play it back later to lamps, relays, magnetic valves, motors and so on. If recording is not

required the sequencer can be omitted:

Contacts → CTM64 → MTC64 → lamps/relays/electromagnets

1 2 ... 10 11 12 13 14 15 16

Pas de commentaire

Doepfer MTC64 Midi to Gate Interface (main board) Manuel d'utilisateur Page 15