Doepfer A-154 Sequencer Controller Manuel d'utilisateur télécharger pdf (Page 13)

doepfer

System A - 100

Sequencer Controller

A-154

Appendix: Connection A-154 – A-155

(1) Disconnect the 10 pin ribbon cable leading from the connector ST1 of the small A-155 controller board to the

bus board. This cable is no longer required. But you may keep it as a bus cable replacement (for other modules with

10 pin connectors).

(2) Disconnect the 10 pin ribbon cable leading from the connector ST2 of the small A-155 controller board to the

other boards of the A-155 (potentiometer and trigger boards). This cable is connected to another ribbon cable co-

ming from the A-154 (see below).

(1) disconnect this cable

(no longer required)

(2) disconnect this cable, will be

connected to a cable coming from A-154

1 2 ... 8 9 10 11 12 13 14 15 16

Pas de commentaire

Doepfer A-154 Sequencer Controller Manuel d'utilisateur Page 13